Useful For Suitable Low-Voltage Electronics Work

Set Up The Probe Before Adjusting The Waveform

1. Check The Signal Before Connecting

Confirm that the circuit voltage, signal type and measurement conditions are within the instrument and probe ratings stated in the instruction manual.

2. Connect The Probe Correctly

Connect the probe reference and signal lead only to appropriate measurement points and use the correct probe setting when applicable.

3. Adjust Time & Voltage Settings

Set the horizontal and vertical ranges so the waveform fits clearly within the display.

4. Choose A Trigger Mode

Use Auto, Normal or Single according to whether you are viewing a repetitive signal or attempting to capture a suitable one-time event.

5. Read & Compare The Waveform

Interpret the displayed waveform within the instrument's bandwidth, sampling and input limitations rather than treating it as a laboratory-reference measurement.

Perform Probe Calibration Before Measurement

Square-Wave Calibration

The supplied instructions recommend performing square-wave calibration during initial setup. Follow the device and probe instructions carefully so the displayed waveform is adjusted correctly before normal measurements.

Specifications

Standard Package

• Read the instruction manual before connecting the oscilloscope to any circuit.
• Never exceed the oscilloscope's or connected probe's stated input-voltage and measurement-category limits. Use the lower applicable rating.
• A P6100 probe or adapter does not by itself make the oscilloscope safe for arbitrary high-voltage or mains measurements.
• Do not connect the instrument to household mains, high-energy circuits or other hazardous voltages unless the complete oscilloscope/probe setup is explicitly rated for that measurement and you are trained to perform it safely.
• Confirm where the probe ground/reference lead is electrically connected before attaching it to a powered circuit. An incorrect reference connection can cause a short circuit, equipment damage or electric shock.
• Use appropriately rated probes, accessories and protective procedures for the circuit being tested.
• The listed 2.5MS/s sampling rate and 200kHz analog bandwidth define important measurement limitations. Signals outside the instrument's capabilities may be displayed inaccurately or incompletely.
• Perform the recommended square-wave calibration during initial setup and whenever required by the probe or operating instructions.
• Charge using the specified 5V/1A USB supply. Avoid unsuitable power sources that may damage the device or battery.
• Do not use or charge the instrument if the housing, battery, charging cable, connector or probe is visibly damaged.
• Keep the device dry and do not operate it in wet conditions or around flammable gases or vapors.
• Only upgraded versions include the adapter and P6100 probe. Check the selected configuration before ordering.
• Store the oscilloscope and probes safely when not in use and keep them away from children.

Beware of Counterfeit & Imitation Products

Please purchase only from the official Charnent @ store.

Unauthorized sellers may use similar product images or descriptions while supplying products that differ in sampling performance, bandwidth, display quality, battery capacity, included probes, accessories, packaging or after-sales support.